Dynavap glass cup w/ silicone for the Wand

I really like this adapter. I found it work best to install the silicone piece from the bottom and then put the cup in from the top side with the button. Set to 150C and you'll never burn you dynavap again

I didn't find this finicky or difficult to use, pretty much plug and play. A little bit of learning and adjustment to the depth helped as I went, but nothing any trickier than using a DV normally, getting a new tip, etc. It sometimes grabs and pulls off my cap, but it's easily avoidable. Being able to set the DV down in it is nice, and by design it heats consistently so once you have it dialed in it's very repeatable.

I ordered this to use with the wand but it did not fit and I even tried inserting it while it was upside down and it still wouldn’t fit. So I made a return it was quite a process and finally they allowed me to send it back. I sent it back, thinking it was potentially a malfunction or a defective w/ the wand or the glass adapter so I ordered it for a 2nd time . Same exact issue and then had to file for a warranty online application to be eligible for a Refund or exchange. Finally they sent me a 3rd one with this glass adapter. And it still doesn’t fit unless i use it facing upside down so I cant see the battery life or the temp, and I assume they changed how it been made from a year or two when I had it.
Using it with this insert, It was hard to hear the click. -it takes longer to heat up my vape and burns it. This means it takes more battery life. -Others recommended to insert the glass from the top and the other piece from the bottom. The glass does not fit from the top therefore the only option is to insert from the bottom. The glass sticks out quite a bit doing so. I started using the wand without the insert and it's so easy to use. I might try to go back to trying out the insert but I don't see it being my preferred way by any means.

I had a hard time dialing in the depth of the cup when it sits in the wand. If you shove the glass bowl in all the way to the bottom of the silicone sleeve the Dynavap tip goes past the point where it gets heated properly and the wand either times out or doesn't recognize the tip. I measured the bepth of my older glass Dynavap adapter bowl that works well and set the depth of the new bowl to match. Eureka! It works! 4mm up from the bottom rim of the wand is the magic spot. It still takes a count of 20 to heat up but I now get good burn on my herb.